Repair Log

Williams Pennant Fever

I’ve done a lot of battery corrosion clean up over the years. It’s a pretty intensive process that involves removing the affected components, sanding down the damaged traces, neutralizing the base corrosive with an acidic solution like vinegar, cleaning the board with isopropyl alcohol, repopulating, testing and botched trace repair, and, finally, sealing the affected areas.

For many years, even relatively damaged System 9, System 11, and Data East boards made sense to save vs consider a replacement option in the ~$500+ range. However, with the recent release of the System Omega board at just $250, it greatly reduces the cost benefit analysis on how much corrosion is worth tackling vs. just putting that board in.

I thought I might finally be done with badly corroded boards, but for my last hurrah, I had one more left and she didn’t pull any punches. Williams made only 2 machines that used the System 8 hardware: Still Crazy, a novelty machine, and this pitch and bat, Pennant Fever. Technically, a System 9 or early 11 board can work in in a System 8 machine, but it requires some relatively extensive modification including adding a display controller board from that era, adapting the connectors, etc.

This game had pretty extensive corrosion damage on the top side and even some all the way through to the back. It required removing and sanding down a large portion of the board. Pictured below is in the middle of that process.

Since the reset section was toast, I opted for a reset generator rather than rebuilding it to spec. The System 8 board was a little different from the 9/11 and there were a few modifications I had to make to get it to all work on this System 8 hardware. I opted for a socketed lithium coin style battery to replace the problematic AA’s.

Once it was all repopulated, the damage was so extensive, that there were several botched traces that I had to repair and the process of getting this from power rail tested on down to booting onto fully functional took a lot of time and was tedious.

I’m happy to report though that Pennant Fever is back up and fully working with its original System 8 hardware in tact. Hopefully, this will be the last very heavy corrosion repair I have to do for some time. I did them more for cost benefit to clients, but unlike normal electrical failures that are fun to trace and hunt down, there is nothing really enjoyable about extensive corrosion clean up and repair outside of the feather in your cap when you save a really bad one.